Skip to content

How To Un Solder Copper Pipe

Copper piping is often used in plumbing because it is durable and resists corrosion. However, at some point, you may need to un solder a copper pipe. This can be done with a few simple steps.

How To Un Solder Copper Pipe

There are a few ways to unsolder copper pipe, but the most common is to use a propane torch. First, make sure the area around the pipe is clear and free of flammable materials. Then, heat the solder around the pipe until it is melted. Next, use a pair of pliers to hold onto the pipe and twist it in opposite directions. This will loosen the solder and allow you to remove the pipe.

– Soldering iron – Flux – Wire brush – Sandpaper – Pipe cutter – Vice grips

  • Wipe down the area with a wet rag to remove any residue
  • Use a soldering iron to heat the copper pipe until the solder liquefies
  • Use a solder sucker or pliers to remove the solder from the pipe

below -heat the soldering iron -apply the iron to the solder joint, and heat it until the solder liquefies -pinch the end of the copper pipe with a pair of pliers -pull the soldering iron away from the solder joint while gently pulling on the pliers to unsolder the pipe


Frequently Asked Questions

How Do You Remove Soldered Copper Fittings?

There are a few ways that you can remove a soldered copper fitting. One way is to use a propane torch. Another way is to use a hacksaw.

Can Solder Be Removed From Copper Pipe?

Yes. Solder can be removed from copper pipe using a flux and a soldering iron. The flux will help to dissolve the solder, and the soldering iron will help to heat the copper pipe and melt the solder.

How Do You Remove A Soldered Copper Fitting?

You can remove a soldered copper fitting by heating it until the solder liquefies and then using a plunger to pull the fitting free.

How Do I Remove A Stubborn Solder Copper Pipe?

There are a few ways to remove a stubborn solder copper pipe. One is to use a propane torch to heat the solder until it liquefies. Another is to use a hacksaw to cut the pipe above the solder and then use a pipe wrench to remove the remaining piece of pipe.

How Do You Remove Solder From A Pipe?

There are a few ways to remove solder from a pipe. One way is to use a solder sucker, which is a tool that uses suction to remove the solder. Another way is to use a soldering iron and some flux. The flux will help to dissolve the solder, and then the soldering iron can be used to remove it.

How Do You Loosen Old Copper Pipe Fittings?

The traditional way to loosen copper fittings is to use a propane torch. Apply the heat to the fitting and then use a wrench to turn it.

Can You Unsweat A Copper Pipe?

Yes, it is possible to unsweat a copper pipe by using a heat gun.


In Summary

There are a few ways to un-solder copper pipe. One is to use a propane torch with a rosebud tip. Heat the solder joint until the solder melts, then use a pliers to twist the pipe until it breaks free. Another way is to use a soldering iron and flux. Apply the flux to the joint, then heat the soldering iron and apply it to the solder joint. When the solder starts to melt, gently pull on the pipe until it comes loose.

Leave a Reply

Your email address will not be published.